Sunday, July 19, 2009

Pressure washer cleaning tip

Instructions for using pressure washer (cold water 3000- 4000PSI)
Steps:


1: Hook up all attachments : Water hose, pressure washer hose, and gun.

2: Turn on the water full force and pull the trigger of the gun. Let the water flow out of the gun for 1 to 2 minutes to get out all the air pockets .

3: While the gun trigger is pulled and water is flowing freely out of the gun:
Turn the gas switch to on position.
Pull the choke out fully when the machine is cold. Once the machine has started, return the choke to its original position. After the machine is warmed up, the choke does not need to be pulled out again to start.

4: Put the throttle lever half way to the middle position and turn the key to start the machine.

5: As the machine gets warm up, you can adjust the throttle to a higher position to get more PSI or lower it for lower PSI.

Turning off the machine:

1: Hold the gun trigger to run the water and turn the gas to off position.
2: Turn the throttle lever to the bottom position.
3: Turn the key to off position and remove the key from the machine.
4: Turn the water off.
5: Pull the trigger to drain all the water remaining in the gun. Then remove the pressure washer hose.
6: Remove the water hose.


*** Important note:
• Do not refuel the tank when the machine is hot. Wait for 10 to 15 minutes to cool the machine down first before refueling.
• Use only unleaded regular gasoline.

• Do not let the machine run more than 2 minutes without shooting the water through the gun. Built up pressure in the machine will either damage the motor or will blow up the machine.
Machine has to be turned off, if you will not be using it for more than 2 minutes.
Machines damaged this way, is not covered under the warranty service.
• Portable gas containers must be clean of any residue or water.

• Do not aim at any plants, living things, etc., with the pressure washer gun when it is running. It will cause great damage or even death.
• When using in areas with loose bricks, stones, grout: Do not use full force PSI. It will cause damage to stones, grout, brick, concrete floor or walls. Lower the PSI by lowering the throttle.
• When washing garage or driveways, run off waters must not go into the storm drains.

Always play safe with any powerful machines such as pressure washers and dealing with gasoline.

Please visit our home website at;
https://www.janitorialcontractorshelp.com

And search for commercial pressure power washers right here at Google site.